Glow in the Dark Anti Slip Tape

glow in the dark anti slip tapeGlow in the dark anti slip tape is a popular material. To combine two very popular products; glow in the dark tape with anti skid tape. Glow in the dark slip tape is produced in three main color options, either plain color, hazard chevrons or Glow Stripe (a 2” black roll with a central stripe of photoluminescent egress tape). In a daytime or lights on scenario the material is a mild green shade, in lights out they emit a bright white glow. The upper resin coating is impregnated with a photoluminescent powder, which contains non-radioactive photons, and these photons absorb energy from either natural or artificial light sources. When lighting diminishes, the powder releases the stored energy as white light. This light helps to safely illuminate many areas:

Stairwells

Areas that can be tricky to navigate in low light or lights out situations, applying glow in the dark safety tape can help illuminate the area, allowing you to quickly, calmly and safely, navigate them in time of need. Whole steps and platforms, if applicable can be highlighted.

Stair Nosings

Stair nosings can be a common place for causes of slips, mis-steps being the most obvious accidents. Applying glow in the dark anti slip tape to the stair nosing can create a hi-viz, non slip edge that will ensure heightened safety when ascending or descending steps.

Access Areas

Highlighting access points is important in not only ensuring they are kept clear, but so they can be easily found during times of emergency. Using a combination of glow in the dark safety tape, can ensure that it remains visible and safe during lights out or low light situations.

Ledges

Reducing risk of falls from ledges is vital, thus adding a hi-viz, anti slip product such as glow in the dark anti slip tape will ensure that slips and mis-steps are less likely to occur.

glow in the dark hazard anti slip tapeThe base is self-adhesive with a permanent adhesive, it adheres securely to almost all surfaces, if applying onto a porous surface such as wood, concrete or stone we recommend using a surface primer prior to application to help create a stable substrate, our video section will show this in detail. Glow in the dark safety tape is supplied in either rolls or die cut shapes. Roll lengths are normally 60’ but any length available from 5’ to 300’ is available, roll widths are from ¾” upto 46” (we can slit to less than 0.5” on special request but we impose a small minimum order quantity as we have to change to special narrow cutting blades). Any shape can be produced and our web fed computer controlled presses are accurate down to fractions of an inch meeting any imposed tolerance. The upper anti skid surface provides industry leading levels of grip, far in excess of any or planned state, federal or international slip standard, we can supply Coefficient of Friction data (how grip levels are measured) to help with insurance requirements if required.

Regulations and Certifications

Below is a table denoting what regulations glow in the dark anti slip tape meets and what certs, if any, are available.

Certifications and Regulations Regulation Met?/Cert Available?
OSHA 29CFR part 1910.23 Check mark symbol
CoF Standards for Americans with Disabilities Act 2008 Check mark symbol
NFSI Certification

For more information on glow in the dark anti slip tape, or to place an order, please contact us by email, phone, live chat or the contact us form on the site.